Liner Tape & Fasteners

This tape is used to seal the seams of the crawl space vapor barrier. It comes in  4" x 187' rolls (compare to rolls at only 108') and is white to match all of the vapor barriers we offer. This product, when installed correctly, will give you a waterproof seal at the seams. In very wet conditions it is recommended to use the Foundation Seal Tape™ under the seam to give an extra layer of protection. This tape is the perfect thickness for this application allowing proper flexibility...

Foundation Seal Tape™ (FST) is used to seal the vapor barrier to the foundation wall. When installed to a completely dry & clean foundation wall, the bond is good enough to hold the vapor barrier to the wall temporarily (several hours/days) until the Foundation Pins are installed. If the foundation wall is wet in the area it will be installed and it will not bond then a polyurethane caulk must be used. This tape is 1.5" x 100' and has a reinforcement inside the tape to eliminate stretching...

The Foundation Pins™ are used to permanently secure the vapor barrier™ to the foundation wall. These pins are inserted into a 1/4" hole drilled by a hammer drill. They are to be installed every two foot, two in each corner and anywhere is cut around obstructions. These pins come in packs of 100 pieces or 1000 pieces and are required for a lasting bond to the foundation wall. The heads of our pins will not break off nor will the pin come out of the hole as with other pins on the market....

These plastic insulation pins are used to mechanically fasten rigid foam board to the foundation wall. This is to be used prior to installing your crawl space vapor barrier, and is not intended to be used on the vapor barrier itself. Requires a 5/16 drill bit for installation.